![]() At the homepage, you can also click on “Manual” to open the Manual Control page, where you can start a test program or any of the existing programs. Click on “Settings” at the lower-left of the homepage, this will open the Settings/Options page (middle image above), where you can configure the time zone, device name, zone name, and other options. The Homepage (left image above) shows the current time, status of each zone, and buttons that lead to other pages. The default device key is opendoor, which you can change in Settings. Open a browser and type in the IP address, it should open OSBee’s homepage show below. ![]() This IP address is printed on the LCD screen at the bottom. In WiFi station mode, OSBee obtains an IP address from your home WiFi router. ![]() ![]() If you want to change the WiFi network, you can perform a factory reset and it will go back to AP mode. From now on, it remembers your WiFi and will always attempt to connect to it when it’s powered on. At this point, OSBee will attempt to connect to your WiFi, and if successful, it will reboot itself, and now WiFi configuration is complete. If you have already created a Blynk app token (see Section 5), you can also paste it here, otherwise, just leave the token blank. So choose, or directly type in your home WiFi’s SSID and WiFi password (Note: it only connects to 2.4G WiFi). The main purpose of the WiFi configuration is to let OSBee know your home WiFi’s name and password, so that it can subsequently connect to your WiFi. This should open the WiFi configuration page. Once connected, open a web browser on your phone (or laptop) and type in the IP address 192.168.4.1. Use your smartphone, or laptop to connect to this WiFi SSID (there is no WiFi password). In this mode, OSBee creates a WiFi SSID, the name of which is printed on the LCD screen (e.g. The first time you power on OSBee, or after each factory reset, the controller starts in AP (Access Point) mode. OSBee is powered by a USB adapter through a microUSB cable. Un-tighten a screw, insert the wire through the opening below it, wrap the wire around the screw, then tighten the screw. At the back of the controller there are four big screws. The positive (+) wire (often colored red) of each valve should be connected together and go to the COM terminal the negative (-) wire (often colored black) of each valve should go to an individual zone (1, 2, or 3). Any services or products provided by independently owned and operated franchisees are not provided by, affiliated with or related to Century 21 Real Estate LLC nor any of its affiliated companies.OSBee has four terminals marked COM (common), Z1 (zone 1), Z2, and Z3. Each office is independently owned and operated. CENTURY 21 Action Plus Realty is a proud member of the National Association of REALTORS®.ĬENTURY 21 ® and the CENTURY 21 Logo are registered service marks owned by Century 21 Real Estate LLC. CENTURY 21 Action Plus Realty fully supports the principles of the Fair Housing Act and the Equal Opportunity Act. CENTURY 21® is a registered trademark owned by Century 21 Real Estate LLC. Data is deemed reliable, but is not guaranteed accurate. IDX property information is provided exclusively for consumers' personal, non-commercial use and may not be used for any purpose other than to identify prospective properties consumers may be interested in purchasing. Property information is provided in part by the Monmouth County Association of REALTORS®.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |